Participants:
Mr. Song Wei Min, President of Beijing Military Technology For Civil Application Society
Mr. Jia Huiyuan, Ex-Director of Beijing Generator Works Co.
Mr. Chen Jianxin, Casting Workshop Director of Beijing Generator Works Co.
Mr. Mr. Zhang Jun, Welder of Beijing Generator Works Co.
Prof. Guangqi Liang and three assistants
Operator
Description:
Organized by Mr. Song Wei Min, President of Beijing Military Technology For Civil Application Society, and Mr. Jia Huiyuan, Ex-Director of Beijing Generator Works Co., the inventor of oPetrol oxy-gasoline cutting torch Prof. Liang Guangqi and his team of four people came to our casting workshop on March 29th of 2001 with their oPetrol oxy-gasoline cutting torch for a site test.
The cutting was performed by Mr. Zhang Jun of our company, who had no prior experience with oxy-gasoline cutting torch. The assistant of Prof. Liang lit the oxy-gasoline torch and adjusted the flame. Without any special training but only some instructions by the professor, Mr. Zhang Jun started the cutting.
Four large size cast steel rising heads were cut. The bottom diameters of these rising heads were 488mm, 485 mm, 500mm and 492mm respectively. The part was placed in a 45o angle as usual.
It Takes the Operator 18 Minutes to Cut a 500mm Steel at Beijing Fangshan Generator Works. (3)
It Took 7.5 Liters of Gasoline to Cut Off All Four Blocks! 488mm, 485mm, 500mm and 492mm in Diameter. (4)
Participants:
Mr. Song Wei Min, President of Beijing Military Technology For Civil Application Society
Mr. Jia Huiyuan, Ex-Director of Beijing Generator Works Co.
Mr. Chen Jianxin, Casting Workshop Director of Beijing Generator Works Co.
Mr. Mr. Zhang Jun, Welder of Beijing Generator Works Co.
Prof. Guangqi Liang and three assistants
Operator
Description:
Organized by Mr. Song Wei Min, President of Beijing Military Technology For Civil Application Society, and Mr. Jia Huiyuan, Ex-Director of Beijing Generator Works Co., the inventor of oPetrol oxy-gasoline cutting torch Prof. Liang Guangqi and his team of four people came to our casting workshop on March 29th of 2001 with their oPetrol oxy-gasoline cutting torch for a site test.
The cutting was performed by Mr. Zhang Jun of our company, who had no prior experience with oxy-gasoline cutting torch. The assistant of Prof. Liang lit the oxy-gasoline torch and adjusted the flame. Without any special training but only some instructions by the professor, Mr. Zhang Jun started the cutting.
Four large size cast steel rising heads were cut. The bottom diameters of these rising heads were 488mm, 485 mm, 500mm and 492mm respectively. The part was placed in a 45o angle as usual.
We have been using 36 units of oPetrol oxy-gasoline cutting systems since May 1999. We did a measurement on the gasoline consumption of the torches. Within 7 months it took us 2.6 tons gasoline (valued about 900 USD), which was 15% of our former cost on acetylene for the same work.. We saved fuel cost by 85%.
There has not been a single time back-flash during our long time heavy duty. It is very safe to use. Our operators are very fond of the new tool.
It is especially handy for operations at remote or high sites.
